nav emailalert searchbtn searchbox tablepage yinyongbenwen piczone journalimg journalInfo journalinfonormal searchdiv searchzone qikanlogo popupnotification paper paperNew
2014, 06, v.23 17-20
苯丙乳液聚合中粒径及稳定性的影响因素研究
Study on influence factors of particle size and stability in styrene-acrylate emulsion polymerization
基金项目(Foundation):
邮箱(Email):
DOI: 10.13416/j.ca.2014.06.005
发布时间: 2014-06-30
出版时间: 2014-06-30
移动端阅读
摘要:

以辛基酚聚氧乙烯醚(OP-10)和十二烷基硫酸钠(SDS)为乳化剂、过硫酸铵(APS)为引发剂和碳酸氢钠为缓冲剂,采用种子乳液聚合法合成了苯丙乳液,并探讨了各因素对乳液粒径和聚合稳定性的影响。研究结果表明:聚合温度升高虽会提高单体转化率,但也会降低乳液的聚合稳定性;当m(SDS)∶m(OP-10)=2∶1、w(打底乳化剂)=30%(相对于总乳化剂质量而言)、w(引发剂)=0.6%和w(缓冲剂)=0.3%(均相对于总单体质量而言)时,乳液的聚合稳定性相对较好;总乳化剂含量和打底单体含量是粒径的主要影响因素,乳液粒径随前者含量增加而下降,随后者含量增加而增大。

Abstract:

With polyoxyethylene octyl phenol ether(OP-10)and sodium dodecyl sulfate(SDS)as emulsifiers,ammonium persulfate(APS)as initiator,sodium bicarbonate as buffer agent,the styrene-acrylate emulsion wassynthesized by seed emulsion polymerization,and the influences of various factors on particle size andpolymerization stability of emulsion were discussed. The research results showed that the monomer conversion ratewas increased but polymerization stability of emulsion was reduced with increasing polymerization temperature. Thepolymerization stability of emulsion was relatively better when mass ratio of m(SDS)∶m(OP-10)was 2∶1,massfraction of pre-added emulsifier was 30% in total emulsifier,mass fractions of initiator and buffer agent were 0.6%and 0.3% respectively in total monomers. The contents of total emulsifier and pre-added monomer were mainfactors that affect the particle size,the particle size of emulsion was decreased with increasing content of the formerbut was increased with increasing content of the latter.

参考文献

[1]黄增芳,马军现.含可聚合乳化剂的苯丙乳液合成及其在复膜胶中的应用[J].中国胶粘剂,2011,20(8):25-28.

[2]Zhu A P,Rong Q P,Chen R.The Preparation of core-shell P(St-MMA)-SiO2hybrid nanoparticles and filling in the styrene/n-butyl acrylate adhesive[J].Journal of Adhesion Science and Technology,2010,24(2):267-280.

[3]项东升,丁易,朱驯,等.高剥离力苯丙乳液压敏胶的研制[J].中国胶粘剂,2012,21(5):34-37.

[4]李顺,兰支利,尹笃林,等.木器漆用自交联改性苯丙乳液的合成以及性能研究[J].涂料工业,2012,42(7):26-30.

[5]Borthakur L J,Jana T,Dolui S K.Preparation of core-shell latexparticlesbyemulsionco-polymerizationofstyreneand butyl acrylate,and evaluation of their pigment properties in emulsion paints[J].Journal of Coatings Technology and Research,2010,7(6):765-772.

[6]闫翠娥,黄世强,封麟先.St-MMA-AA三元无皂共聚胶乳性质的研究(I):胶粒形态、大小及分布[J].高分子材料科学与工程,2000,16(6):75-78.

[7]史修启,王红霞,张剑,等.非离子表面活性剂微乳液中苯乙烯聚合[J].化学试剂,2005,27(9):516-518.

[8]Yuan Q C,Hou R Z,Aryanti N,et al.Manufacture of controlled emulsions and particulates using membrane emulsification[J].Desalination,2008,224(1/3):215-220.

[9]曹同玉,刘庆普,胡金生.聚合物乳液合成原理性能及应用[M].2版.北京:化学工业出版社,2007.

[10]冯小平,李胜华,何伟,等.丙烯酸酯乳液型压敏胶的聚合稳定性研究[J].中国胶粘剂,2010,19(9):23-26.

基本信息:

DOI:10.13416/j.ca.2014.06.005

中图分类号:TQ316.334

引用信息:

[1]许健兴,彭奇均.苯丙乳液聚合中粒径及稳定性的影响因素研究[J].中国胶粘剂,2014,23(06):17-20.DOI:10.13416/j.ca.2014.06.005.

Citation Information:

[1]Xu Jianxing,Peng Qijun.Study on influence factors of particle size and stability in styrene-acrylate emulsion polymerization[J].中国胶粘剂,2014,23(06):17-20.DOI:10.13416/j.ca.2014.06.005.

发布时间:

2014-06-30

出版时间:

2014-06-30

引用

GB/T 7714-2015 格式引文
MLA格式引文
APA格式引文